Admin-Ahead Community
General Category => General Discussion => Topic started by: Aby on December 28, 2013, 06:40:48 am
-
Example of Port Security on an Isolated Private VLAN Host Port
The following example shows how to configure port security on an isolated private VLAN host port, Fast Ethernet interface 3/12:
---
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# vlan 6
Switch(config-vlan)# private-vlan isolated
Switch(config-vlan)# exit
Switch(config)# vlan 3
Switch(config-vlan)# private-vlan primary
Switch(config-vlan)# private-vlan association add 6
Switch(config-vlan)# exit
Switch(config)# interface fastethernet 3/12
Switch(config-if)# switchport mode private-vlan host
Switch(config-if)# switchport private-vlan association host 3 6
Switch(config-if)# switchport port-security
Switch(config-if)# end
---